Operation; To Charge The Battery - Husqvarna WT 15i Manuel D'utilisation

• Do not use a defective or damaged battery charger.
• Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
• Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the cable
is not caught between doors, fences or equivalent.
• Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
• Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
To fill the water tank
Note: Only put water in the tank. Do not put any other
liquid in the water tank.
Note: Do not put the water tank in water.
1. Remove the water tank cap.
1572 - 001 - 21.12.2020
the battery outdoors. Do not charge the battery in
wet conditions.
• Only use the battery charger where the temperature
is between 5 °C (41 °F) and 40 °C (104 °F). Use the
charger in an environment which has a good airflow,
dry and free from dust.
• Do not put objects into the air slots of the battery
charger.
• Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
• Do not charge non-rechargeable batteries in the
battery charger or use them in the machine.
• Use approved mains sockets that are not damaged.

Operation

2. Fill the water tank with water.

To charge the battery

CAUTION: Make sure that the battery, the
battery charger and the terminals on the
battery are clean and dry. Do not put the
battery in the battery charger if it is dirty or
wet.
1. Connect the battery charger to a power outlet. The
charging LED flashes 1 time.
2. Connect the battery to the battery charger. The
charging LED comes on.
3. Remove the battery from the battery charger.
H O
2
CAUTION: Only connect the battery
charger to a power outlet with the
voltage and frequency specified on the
rating plate.
5