Publicité
7.2 Manual pairing
1.
Ensure that all the cables are well connected
and the soundbar is in Standby mode.
2.
Press and hold the PAIR button on the rear
of the subwoofer for a few seconds. The
subwoofer will enter the pairing mode and
the Pair Indicator will blink quickly.
3.
Press the
button on the soundbar or on the
remote control to switch the soundbar on.
4.
Press and hold the
or on the remote control for a few seconds.
5.
After the wireless connection succeeded, the
Pair Indicator will light up.
6.
If the Pair indicator blinks, the wireless
connection has failed. Unplug the cable of
the subwoofer and then reconnect the main
cable after 4 minutes. Repeat step 1 ~ 4.
NOTE:
•
If the wireless connection fails again, check
if there is con ict or strong interference (for
example, interference from an electronic
device) around your location. Remove these
conflicts or strong interferences and repeat
the above procedures.
•
The subwoofer should be within 6m (19.7 feet)
of the soundbar in an open area.
•
If the soundbar is not connected with the
subwoofer and it is in On mode, the POWER
Indicator will flash. Follow step 1 ~ 4 above
to pair the subwoofer to the soundbar.
button on the Soundbar
8. Basic Operation
8.1 Standby/ON
It will automatically turn on when the power cord
is connected.
•
Press the
button to switch the soundbar
STANDBY mode.
•
Disconnect the mains plug from the mains
socket if you want to switch the soundbar
OFF completely.
8.2 Auto-Standby / Auto-Wake Feature
[Auto -Standby] Your soundbar has been
p r o g r a m m e d t o e n t e r S TA N D B Y m o d e
automatically when no audio is detected for 15
minutes. For example, this would happen when
pausing playback, or should the soundbar be left
on accidentally.
[Auto-Wake] If a TV or an external device is
connected (AUX / OPTICAL / HDMI ARC mode), the
unit will switch on automatically when the TV or
the external device is switched on.
To disable this feature, please follow the steps
below:
1.
During ON mode, press and hold the
button for 3 seconds to open the menu.
-
The unit's display will scroll "MENU".
2.
Press the
button 6 times in succession:
the display shows: Auto Wake [ON / OFF].
or Press the
button 7 times in succession:
the display shows: Auto Standby [ON / OFF].
3.
Select the content with VOL+ /
the remote control, and then press the
button to con rm your selection and exit the
settings.
•
Repeating these steps will toggle the feature
"ON" and "OFF".
EN
buttons on
11
Publicité
