Troubleshooting Guide - DeWalt DCN701 Guide D'utilisation

English
Many common problems can be solved easily by utilizing the chart below. For more serious or persistent problems,

WARNING: To reduce the risk of serious personal injury, ALWAYS disconnect battery pack from tool before
all repairs.
SYMPTOM
Tool will not fire
Tool operates but does not drive
fasteners fully
Tool operates, but no fastener
is driven
Jammed staples
Staples do not fit
14

TROUBLESHOOTING GUIDE

contact a D WALT service center or call 1-(800)-4-D
e
CAUSE
Dryfire lock out engaged, blocking wire
indicator from traveling fully.
Battery is hot.
Tool is hot.
Bent contact trip.
Terminals are dirty or damaged.
Damaged internal electronics.
Damaged trigger.
Jammed staple/drive blade not returned
to home position.
Damaged driver.
Jammed internal mechanism.
Damaged internal electronics.
Tool not firmly applied to workpiece.
Damaged or worn driver tip.
Damaged actuation mechanism.
Wrong size or staples.
Debris in nosepiece.
Debris in magazine.
Damaged pusher spring.
Worn magazine.
Wrong size or staples.
Magazine not secured after previous jam
clear/inspection.
Material and fastener length.
Debris in nosepiece.
Worn magazine.
Damaged pusher spring.
Damaged or worn driver.
Confirm D WALT staples are being used. Your stapler is only compatable with D
e
WALT.
e
FIX
Load more staples into magazine.
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
See authorized service center.
See authorized service center.
See authorized service center.
See authorized service center.
Remove battery, clear jammed staple, reinsert battery pack, driver blade
will reset by using the tool normally (first cycle will not fire a staple).
See authorized service center.
See authorized service center.
See authorized service center.
Apply adequate force to tool securing it tightly to workpiece. Refer to
Actuating the Tool.
See authorized service center.
See authorized service center.
Use only the recommended staples. Refer to Staple Specifications.
Clean nose area and watch closely for small pieces of broken staples stuck
in the track.
Clean magazine.
Replace spring. See authorized service center.
Replace magazine. See authorized service center.
Use only the recommended staples. Refer to Staple Specifications.
Make sure the magazine is latched properly.
If the unit continues to stall, see authorized service center.
Clean nose area and watch closely for small pieces of broken staples stuck
in the track.
Replace magazine. See authorized service center.
Replace springs. See authorized service center.
Replace driver with kit.
WALT staples.
e