Publicité
Min/max continuous measurement:
Device on
1 sec
1x
The LC display shows the max value, the min value and the current value.
Memory function:
or
Error codes:
Replace the battery
Err101:
Calculation error
Err104:
Temperature is too high: > 40°C
Err152:
Err153:
Temperature is too low: < 0°C
Outside the measuring range
Err154:
Received signal too weak
Err155:
Received signal too strong
Err156:
Incorrect measurement or background is too bright
Err157:
The device is moving too much to measure.
Err160:
Important notices
– The laser points to the location that will be measured.
No objects may get into the laser's line of measurement.
– The device compensates the measurement for different room
temperatures. Therefore allow the device a brief adaptation period
when changing locations with large temperature differences.
– The device is only conditionally useable in outdoor areas and cannot
be used in strong sunlight.
– The measurement results of outdoor measurements may be influenced
or falsified by rain, fog and snow.
– In unfavourable conditions, e.g. with poorly reflecting surfaces, the
maximum deviation may be greater than 3 mm.
– Carpeting, upholstery or curtains will not reflect the laser optimally.
Measure to flat surfaces.
– Measurements made through glass (window panes) can falsify
measurement results.
– An energy-saving function switches the device off automatically.
– Clean with a soft cloth. Water may not be allowed to penetrate
the housing.
12
EN
Press for 3 seconds
then release button
3 sec
2x
3 sec
View stored values
Stop
3x
Publicité
