Publicité
EN
Pack Contents
The following is included:
•
POLAR Refrigerator
•
Instruction manual
•
Spacer (x2)
POLAR prides itself on quality and service, ensuring
that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: Not for use in vans or
trailers, food trucks or similar
vehicles.
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
To avoid being pushed tight
against the wall accidentally
and ensure good ventilation,
2 spaces are supplied for
mounting on the rear.
Note: Before using the appliance
for the first time, clean the
interior with soapy water then
dry well.
3. Set the brakes on the castors to keep the
appliance in position.
4
DA546-DA549_ML_A5_v4_20240924.indb 4
DA546-DA549_ML_A5_v4_20240924.indb 4
Operation
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
•
Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
•
Do not place uncovered items as below inside
the appliance, as this can lead to a damaged
and leaking evaporator, and thus void your
warranty: hot food, hot liquids, acidic fluids,
acidic products.
•
Wrap or cover food where possible.
•
Do not obstruct the fans inside the appliance.
•
Avoid opening the doors for prolonged periods
of time.
Turn On
1. Ensure the power switch is set to [O] and turn
on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Control Panel
Set the Operating Temperature
1. Hold the SET button for 3 seconds. The value
of the current set point will be displayed.
2. Press the
or
buttons to display the
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
•
The appliance will automatically run a defrost
cycle every six hours.
•
To manually defrost the appliance: Press
and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
•
The defrost cycle will end automatically.
2024/9/24 15:33
2024/9/24 15:33
Publicité
