Stid SPECTRE Notice D'installation page 3

UHF SPECTRE Access module
Installation procedure
In order to access the module connectors, open
hatch.
Cable glands (Data Bus - Power sup. - Input/Output)
J6 Use this (on RS485 connection) when the distance of the data cable is near or over 100 m / 328.08 ft and the signal is
J9
J7
J14
IN 1-2-3-4
OUT 1-2-3-4
V- opt
V+ opt
DATA1 Data or D0 Channel 1 or Tx (RS232) or L+ (RS485)
CLK1 Clock or D1 Channel 1 or L- (RS485)
DATA 2 / CLK2 Data/Clock or D0/D1 Channel 2
DATA 3 / CLK3 Data/Clock or D0/D1 Channel 3
DATA 4 / CLK4 Data/Clock or D0/D1 Channel 4
ALIM
GND
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1127X08 - Page 2 sur 15 - Ed. 28/10/2024
STid reserves the right to make change without notice, for the purpose of product improvement.
Module UHF SPECTRE Access
Notice d'installation
only the hatch provided for this purpose by unscrewing the 4 captive screws without removing them from the
Front View of the module
Green LED
Red LED
TTL / RS232 / RS485 Connection
weakened (polluted signals, frame errors etc.).
Micro USB connector for configuration purposes only
Use this connector for earth connection purpose
Read-only
Low polarization potential of opto-coupled inputs and outputs
High polarization potential of opto-coupled inputs and outputs
Módulo UHF SPECTRE Access
Manual de instalación
Host Connection
RF port 1 RF port 2
End of line resistor RS485
TTL output level: +5V or Vin
OSDP
TM
4 opto-coupled inputs
4 opto-coupled outputs
L+ (RS485)
L- (RS485)
Power supply
GND
RF port 3 RF port 4
SSCP
Tx (RS232) or L+ (RS485)
Rx (RS232) or L- (RS485)
Not used
Not used
Not used
US
FR
ES
®