Publicité
is satin smooth, wipe it down very carefully to remove
dust and then apply one or two coats of primer.
Lightly sand the base layer with fine sandpaper be-
fore applying the top layer. When sanding painted or
painted surfaces, regularly check that the sandpaper
is not covered by the rubbery material of the treated
surface. If this happens, replace the sandpaper.
CLEANING AND MAINTENANCE
! Before cleaning and maintenance, always pull the
power cord of the tool from the socket.
The tool does not require any special maintenance.
Clean the ventilation holes regularly.
Never clean any part of the tool with a hard, sharp or
rough object.
Storage when not in use for a long time
Do not store the tool in a place where the temperature
is high.
If possible, store the device in a place with constant
temperature and humidity.
SPECIFICATIONS
Power supply values 230 V~50Hz
Power consumption 150W
Idle speed 11,000 min-1
Grinding surface 90x187mm
Weight 1.2 kg
Protection class II.
Sound pressure level measured according to EN
60745:
LpA (sound pressure) 88 dB (A) KpA=3
LWA (acoustic power) 99 dB (A) KwA=3
Take appropriate measures to protect your hearing!
Use hearing protection whenever the sound pressure
level exceeds 80 dB (A).
Weighted effective acceleration value according to
EN 60745: 9,569 m/s2 K=1.5
Caution: The vibration level may vary during power
tool operation from the declared value depending on
the way the power tool is used and depending on
the following conditions: Method of power tool use
and type of material being cut or drilled, conditions
of the power tool and method of its maintenance,
appropriateness of the used accessories and ensur-
ing its sharpness and good conditions, the strength
of handle gripping, use of anti-vibration equipment,
suitability of the power tool for the purpose for which
it has been designed and compliance with workflows
according to manufacturer's instructions.
If this power tool is used in an inappropriate manner, a
hand/shoulder vibration syndrome may appear.
Caution: For clarification, it is necessary to consider
the level of vibrations in specific conditions of use in all
operating modes, e.g. the time when the power tool is
switched off except for the operation time, and when
it idles, i.e. performs no work. This may substantially
decrease the exposition level during the whole operat-
ing cycle.
Minimize the risk of vibrations, use sharp chisels, drill
and blades.
Keepthe power toolin compliancewith theseinstruc-
tions and provide for its proper lubrication.
When using the power tool regularly, invest into anti-
vibration equipment.
Do not use the power tool under temperatures lower
than 10°C. Plan your project containing work with the
power tool producing high vibrations carefully and
spread it over more days.
Subject to changes.
ENVIRONMENTAL PROTECTIONWASTE MA-
NAGEMENT
Power tools, accessories and packaging should be
provided for recycling and not to harm the environment.
Do not dispose of power tools into household waste!
According to Directive 2012/19/EU of the European
Parliament and of the Council on waste electrical and
electronic equipment (WEEE) and its approximation
in national laws, unfit power tools must be handed
over at the point of purchase of similar equipment, or
in available collection points designated for collection
and disposal of power tools. Such disposed power
tools will be collected, disassembled and delivered for
environment-friendly recycling.
WARRANTY
In the attached material, you will find our warranty
conditions.
Date of Manufacture
The date of manufacture is incorporated into the serial
number stated in the product nameplate.
The serial number has the format of ORD-YY-MM-
SERI, where ORD is the number of purchase order, YY
stands for the year of manufacture, MM is the month
of manufacture and SERI means the serial product
number.
40
Publicité
