Publicité
INSTALLATION
Mounting
Drilling the Support surface and Fitting the Hood
• The hood support surface must be 135 mm above the bottom
surface of the wall units.
• Drill the support with a ø 4,5 mm drill bit, using the drilling template
provided.
• Cut a hole ø125 or 155 mm in size on the support surface, using
the drilling template provided.
• Fix using the 4 screws '12a' (4,2 x 44,4) provided.
Fitting the cooker hood in a cupboard without shelf
• Saw a 510 x 265 cm opening in the underside of the cupboard.
• Fit the cooker hood into the opening in the cupboard using the
2 quick release skewers.
• If there is no bottom to the cupboard, fit the cooker hood using the
supplied cupboard brackets and quick release skewers.
Closing element
• The space between the edge of the hood and the rear wall can be
closed by applying the element '20' provided, using the screws
supplied for this purpose.
264
15
2x
EN 11
Publicité
