Publicité
EN
Residual risks
• Risk of personal injury from contact with the chain.
• Risk of personal injury from ejected parts of the chain or guide bar.
• Risk of personal injury from ejected pieces of the workpiece.
• Risk of hearing impairment if ear protection is not used.
• Risk of personal injury as a result of inhaling particles of the sawn wood.
• Risk of personal injury from contact with oil.
To reduce these risks, always use the recommended personal safety equipment.
Reduction of noise and vibration
To reduce noise and vibrations when using the machine, limit the time the machine is in use, use low-power vibration and noise modes and suitable safety
equipment. Plan the work so that exposure to heavy vibrations is spread over a longer period.
Take the following precautions to minimise the risks of exposure to vibrations and/or noise:
• Only use the tool in accordance with these instructions.
• Check that the tool is in good condition.
• Use accessories that are in good condition and are suitable for the specific purpose of use.
• Keep a firm grip on the handles/ grips.
• Maintain and lubricate the tool in accordance with the instructions.
WARNING! The actual vibration level when using power tools may differ from the specified maximum value, depending on how the tool is used. It
is therefore necessary to determine which safety precautions are required to protect the user, based on an estimate of exposure in actual operating
conditions (taking into account all stages of the work cycle, e.g. the time when the tool is switched off and when it is idling, in addition to the start-
up time).
INTENDED USE
The electric chain saw must only be used to saw wood, with a chain of the recommended type. Do not use the saw for any other purpose.
Never modify the saw in any way and do not use parts that are not approved by the manufacturer. This can result in damage or injury.
The electric chain saw must only be used for its intended purpose and in accordance with these instructions. Any other use is considered to be unsuitable.
SPECIFICATIONS
Technical Data
Model
Voltage
Power
No load speed
Guide bar length
Cutting speed
Oil tank capacity
Cable length
Weight
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes
significantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also
concern other models of the manufacturer's product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury
or death. The manufacturer and the importer shall not be liable for injuries and damages resulting from the use of non-conforming equipment.
6
EC2035
220 V
1800 W
7500 rpm
350 mm
14 m/s
120 ml
0.25 m
4.4 kg
WWW.NIKOLAOUTOOLS.COM
Main Parts (Img. 1)
1. Front handle
2. Kickback guard
3. Chain
4. Guide bar
5. Sprocket nose
6. Lock nut
7. Casing
8. Bumper spike
9. Clamping screw
10. Screw
11. Oil hole
12. Chain drive sprocket
13. Power switch
14. Lock button
15. Back handle
16. Power cord
17. Cable strain relief clamp
18. Hand guard
19. Ventilation openings
20. Oil level inspection gauge
21. Filler cap for chain oil
22. Guide bar guard
23. Spanner
Publicité
