Publicité
STEP 14
With the help of someone else, carefully turn the unit over on its front
side. Position back panel (M) as shown. Start with attaching back panel
to rear legs (I&K) with screws (6) but do not fully tighten screws. Flush
bottom edge of back panel with bottom edge of bottom (D) and nail
straight into back edges of top (C) and bottom (D) as shown. Now
tighten screws (6).
6
Flush bottom edge of the back
panel with the bottom edge of
bottom (D).
9
6
(x16)
(x8)
D
IMPORTANT! THE BACK PANEL IS A STRUCTURAL PART OF THIS
UNIT AND MUST BE INSTALLED PROPERLY.
21
9
A
Assure that our unit is square.
Distance from corner to corner
must be equal as shown.
6
Publicité
