6.5 Connect Power
Risk of product damage!
•
Risk of product damage! Ensure that the
power supply voltage corresponds to the
voltage printed on the back or the underside
of the soundbar.
•
Before connecting the AC power cord, ensure
you have completed all other connections.
•
Soundbar
Connect the mains cable to the AC~ socket of
the soundbar and then into a mains socket.
Subwoofer
•
Connect the mains cable to the AC~ socket
of the subwoofer and then into a mains
socket.
* Power cord quantity and plug very by regions.
7. Pair up with the Subwoofer
and Rear Surround Speakers
Automatic pairing
The subwoofer and surround will pair
automatically with soundbar upon first use.
•
Determine the status based on the wireless
Subwoofer and surround indicator.
LED State
Status
Fast blink
Subwoofer and Surround in pairing mode
Constant on
Connected / Pairing successful
Slow blink
Connection / Pairing Failed
NOTE:
Do not press the Pair button on the rear of
-
the subwoofer
and surround
pairing.
-
If the automatic pairing fails, pair the subwoofer
with the main unit manually.
Manual Pairing
1
2
3
4
5
6
Tips
•
•
•
, except for manual
Ensure that all cables are well connected and
the main unit is in Standby mode.
Press the
button on the unit or remote
control to switch the main unit on.
Press and hold the
button on the
Soundbar or on the remote control for a few
seconds to enter pairing mode. The display will
scroll "SW PAIRING".
Press and hold the PAIR button on the
Subwoofer or Surround for a few seconds.
The Subwoofer or Surround enter the pairing
state. The Pair indicator on the Subwoofer or
Surround will blink quickly.
After the wireless connection succeeded, the
Pair indicators will light up and the display
on main unit will show "SW IN".
If the Pair indicator blinks, the wireless
connection has failed. Unplug the cable
of the Subwoofer or Surround and then
reconnect the main cable after 3 minutes.
Repeat step 1 ~ 4.
If the wireless connection fails again, check
if there is a conflict or strong interference
(e. g. interference from an electronic device)
around the location. Remove these conflicts
or strong interferences and repeat the above
procedures.
The Subwoofer&Surround should be within 6
m of the Soundbar in an open area.
If the main unit is in On mode, and not
connected with the subwoofer and the rear
surround speakers, the indicators on the
subwoofer and the rear surround speaker
will flash slowly. Follow step 1~4 above to
pair the subwoofer and the rear surround
speakers to the main unit.
EN
11