Trouble Shooting - Topcom Butler 2562 Mode D'emploi

HL_B2562_v3.qxd
ENGLISH

8. TROUBLE SHOOTING

Symptom
No display
No tone
The icon
flashes
Base or handset
do not ring
Tone is good, but
there is
no communication
Not possible to
transfer a call
on PABX
Telephone does not
react to pressing
the keys
32
24-03-2003 10:01
Possible cause
Batteries uncharged
Handset turned OFF
Telephone cord badly connected
The line is occupied by another
handset
Handset out of range
The base has no power supply
The handset is not registered
on the base
The ringing volume is zero or low
The dialling mode is wrong
The FLASh time is too short
Manipulation error
Page 32
Solution
Check the position of the batteries
Recharge the batteries
Turn ON the handset
Check the telephone cord connection
Wait until the other handset hangs up
Bring the handset closer to the base
Check the mains connection to the base
Register the handset on the base
Adjust the ringing volume
Adjust the dialling mode (pulse/tone)
Set the unit to Long Flash time
Remove the batteries and
but them back in place
Topcom Butler 2562