Publicité
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on the
trimmer head.
Spool
cover
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
Hole
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap counterclockwise to wind the cutting
line into the trimmer head. Keep approximately 5 in of
cutting line on each side of the trimmer head.
English
11
Remove the battery pack from the machine before
transportation and storage.
11.1
•
Remove the battery pack from the machine.
•
Make sure that children cannot come near the machine.
•
Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
Bump
•
Secure the machine during transportion to prevent
head
damage or injury. Clean and examine the machine for any
damage.
12
Problem
The ma-
chine does
not start
when you
push the
trigger.
11
TRANSPORTATION AND
STORAGE
WARNING
STORE THE MACHINE
TROUBLESHOOTING
Possible Cause
Solution
No electrical con-
1. Remove battery pack.
tact between the
2. Check contact and in-
machine and the
stall the battery pack
battery pack.
again.
The battery pack is
Charge the battery pack.
depleted.
The lock-out but-
1. Pull the lock-out but-
ton and trigger are
ton and hold it.
not pushed at the
2. Pull the trigger to start
same time.
the machine.
EN
Publicité
