Publicité
EN
10.2
CLEAN THE MACHINE
•
Clean the machine after each use with a moist cloth
dipped in neutral detergent.
•
Do not use aggressive detergents or solvents like "glass
cleaner" to clean the plastic parts or handles.
•
Keep the trimmer head free from grass, leaves, or
excessive grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
•
Do not spray water onto the motor and electrical
components.
10.3
REPLACE THE SPOOL
1. Push the tabs (19) on the sides of the trimmer head at the
same time.
2. Pull and remove the spool cover (18).
3. Remove the remaining spool (20).
4. Put the new spool in the spool cover.
Make sure that the cutting line is in the slot on the new
spool, and is extended approximately 6" (15 cm) before you
install the new spool.
5. Put the ends of the cutting lines through the holes (21).
6. Extend the cutting line to release it from the guide slot in
the spool.
7. Install the spool and spool cover onto the trimmer head.
18
19
20
21
22
NOTE
English
8. Push the spool cover until it clicks into position.
10.4
REPLACE THE BUMP KNOB
1. Push the tabs on the sides of the trimmer head at the same
time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Hold the bump knob and firmly pull it out.
5. Put the new bump knob onto the spool.
10.5
INSTALL THE CUTTING LINE
Do not put more than 13 feet of cutting line in at a time.
10
NOTE
Publicité
