Velleman HAMGSM133 Notice D'emploi page 11

Request alarm condition time-outs
Command: OSS?
Example: OSS?
Get a list of the alarm condition time-outs on both inputs.
Alarm SMS content when input 1 tension is high
Command: TIN1A:xxxxxxxx
Example: TIN1A: TENSION ON INPUT 1
When tension is detected on input 1, an SMS is sent out with text "TENSION ON INPUT
1".
Default: ALARM! INPUT 1 HIGH
Note: a semi colon (;) is not allowed inside the message
Alarm SMS content when input 1 tension is low
Command: TIN1B:xxxxxxxx
Example: TIN1B1: NO TENSION ON INPUT 1
When no tension is detected on input 1, an SMS is sent out with text "NO TENSION ON
INPUT 1".
Default: ALARM! INPUT 1 LOW
Note: a semi colon (;) is not allowed inside the message
Alarm SMS content when input 2 tension is high
Command: TIN2A:xxxxxxxx
Example: TIN2A: TENSION ON INPUT 2
When tension is detected on input 1, an SMS is sent out with text "TENSION ON INPUT
2".
Default: ALARM! INPUT 2 HIGH
Note: a semi colon (;) is not allowed inside the message
Alarm SMS content when input 2 tension is low
Command: TIN2B:xxxxxxxx
Example: TIN2B: NO TENSION ON INPUT 2
When no tension is detected on input 1, an SMS is sent out with text "NO TENSION ON
INPUT 2".
Default: ALARM! INPUT 2 LOW
Note: a semi colon (;) is not allowed inside the message
Activate a relay output
Command: OUTx:ON
Example: OUT1:ON
Activate output relay 1
Deactivate a relay output
Command: OUTx:OFF
Example: OUT2:OFF
Deactivate output relay 2
15/12/2011
xxxxxxxx = message (max. 100 characters, all capitals)
xxxxxxxx = message (max. 100 characters, all capitals)
xxxxxxxx = message (max. 100 characters, all capitals)
xxxxxxxx = message (max. 100 characters, all capitals)
x = 1 (output 1) or 2 (output 2)
x = 1 (output 1) or 2 (output 2)
HAMGSM133
11
© Velleman nv