Turntable and Turntable Support
Remove the turntable and turntable support and wash them in
mild, sudsy water. For stubborn stains, use a mild cleanser and
non-abrasive scouring sponge. You can also wash them in the
top rack of a dishwasher.
The turntable motor shaft is not sealed, so excess water or
spills should be wiped up immediately.
Cleaning and Replacing the Filters
Cleaning the Grease Filters
CAUTION
To avoid risk of personal injury or property damage, do not
operate oven hood without filters properly in place.
Surface lights
Tab
Grease Filters
1.
To remove the grease filters, slide the filter to the rear. Then
pull filter downward and push to the other side. The filter
will drop out. Repeat for the second filter.
2. Soak the grease filters in hot water using a mild detergent.
Rinse well and shake to dry or wash in a dishwasher. Do
not use ammonia. The aluminum on the filter will corrode
and darken.
3. To reinstall the grease filter, slide it into the side slot, then
push up and toward oven to lock. Reinstall the second filter
using the same procedure.
Replacing the Charcoal Filter
Charcoal Filter installed in your microwave oven, is used
for non-vented, recirculated installation. The filter should
be changed every 6 to 12 months depending on use.
CCD-0006074 Rev: 11-15-23
1.
Disconnect power to the microwave oven at the circuit
breaker panel or by unplugging.
2. Remove the vent grill mounting screws.
3. Pull the vent grill away from the unit.
4. Remove the charcoal filter by pushing the top of the filter
inwards, then pull it forward out from the unit.
Front
Rear
5. Slide the top of the new charcoal filter into the top area of
the filter cavity.
6. Press the bottom of charcoal filter to place it into the
correct position.
7.
Put the vent grille bottom tabs into the slots then push the
top of the vent grille into place.
- 19 -
®