Assembly; Unpacking The Generator; Carton Contents - Briggs & Stratton 01655-3 Manuel D'utilisation

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115. If calling for assistance, please have the
model, revision, and serial number from the serial number
label available. See "Know Your Generator" for location.

Unpacking the Generator

1. Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install handle.

Carton Contents

Check all contents against those listed below:
• Main unit
• Handle
• Locking 30 Amp plug
• Engine oil
• Two packets of fuel stabilizer
• Handle attachment hardware
• Operator's manual
• Engine operator's manual
If any parts are missing or damaged, call the generator
helpline at 1-800-743-4115.
ASSEMBLY
www.mymowerparts.com
Attach Handle to Unit
1. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of the
unit and attach a plastic knob from inside of unit
(Figure 2).Tighten by hand.
Figure 2 — Secure Handle
6
Handle
Handle
Supports