Publicité
ENERGIZER SOLAR PEAK 300
Use
On and Off
Press the main power switch to turn on the device, then the screen will be lit and the main power indicator will enter
•
the slowly blinking light mode.
If no operation is performed to the power station for 5 minutes, the power station will enter hibernation state and
•
the LCD will automatically turn off. When there is load change or operation to the power station, the LCD screen will
illuminate automatically. Press the main power switch to turn on or turn off the LCD.
Press and hold the main power switch to toggle the LCD on or off.
•
In the normal mode (the power is above 5%), the default standby time of this product is 2 hours; when the AC
•
output switch is not turned on, and there is no charge or discharge for 2 hours, the product will automatically shut
down, and the standby time can be set it on the Energizer Solar Portable Power App; when the power is 5% or
below, the product will be forced to enter the low power mode. In the case of no charge or discharge, the product
will adjust the standby time according to the power and automatically shut down.
In normal mode, long press the LED light button to exit the automatic shutdown setting, and the battery icon
•
the screen will flash. Long press again to enter the automatic shutdown setting, and the battery icon
flash. The automatic shutdown setting is to protect the battery from low power, exiting this setting may damage the
battery life, please use it with caution.
Note: With no AC input active, long press the above AC output button, you can switch the AC off-grid output frequency
(
/
), long press 2s to switch, the AC output icon will flash 3 times after successful switching.
Short press
LED light button
LED lights
Short press the LED light button to switch between four
modes, which are low light, medium light, high light, SOS
and light off.
8
Short press to turn on
Long press to turn off
will not
ENGLISH
on
Publicité
