Publicité
➊
➋
➌
④
1. Engage the tabs in the output module slot and tip the
Wireless Valve Output Module into place until the connector
is fully seated.
2. Move the locking lever to the horizontal position to secure
the module.
3. Press and release the Reset button on the back of the facepack
so the new module is recognised. The controller can now
manage 54 stations.
4. When powered on, the module's top LED will display a constant
green light to indicate it is active and ready to communicate.
Note
P/MV Connection: If wireless control of a P/MV output will
be used, connect a jumper wire from the P/MV terminal on
the Wireless Valve Output Module to the P/MV output on
the controller power module.
Installation
P/MV Jumper Wire
P/MV
11
Publicité
