Publicité
USE
Remote control
Controls
Connecting the remote control to the appliance
If the appliance cannot be operated with the remote control, e.g. after
the battery has been changed, the connection between the remote
control and the appliance must be re established.
1. Press and hold the '+' button.
2. Attach the appliance to the mains voltage.
▷ A long audible signal sounds. The remote control has been
connected to the appliance.
Note: If no audible signal sounds within 30 seconds, repeat this
procedure.
Switching on the fan
1. Press the '+' button.
▷ The extraction level starts at second speed.
Adjusting the extractor capacity
1. Press the '-' or '+' button to select a higher or lower setting.
▷ The maximum setting you can select is the intensive setting 4.
▷ The run time of the intensive setting is 4 minutes. Once this time
has elapsed, the fan switches to a lower level.
Switching off the fan
1. Press the Off button or:
Press the '-' button until the fan switches Off.
Switching lighting on and off
1. Press the light button.
▷ The lighting comes on.
2. Press the light button again and the lighting fades to off.
Dimming the lighting
1. To dim the lighting, press and hold the light button until the dimmer
function is activated.
▷ The lighting comes on at maximum intensity and it decreases as
long as you hold down the button.
▷ At lowest dimmer setting the light will go back from dimmed light
to brighter light.
EN 5
Publicité
