Publicité
baby unit icons
Degree
TEMPERATURE
Celsius
Fahrenheit
BATTERY
ON
Empty and needs to be recharged
Low
Medium
Full
baby unit LEDs
H
LED
FUNCTION
COLOUR
H
Sensor pad
Green
status
I
Alarm
Red
Flashing red
6
I
INDICATION
Sensor pad connection is good and movement
is detected from the sensor pad
No movement is detected at least in last 20s
Baby has started to move again, but there has
been an issue with the baby
charging your monitor before first use:
THE PARENT UNIT:
The parent unit is supplied with rechargeable batteries 2 x AAA (LR3) that should be inserted before use.
1
To insert batteries, open the battery casing with a screwdriver. Insert the supplied 2 x AAA (LR3)
2
rechargeable batteries. Take extra care to ensure that the batteries are inserted correctly and the right
way round. Refit the battery casing securely with a screwdriver.
3
DO NOT use non-rechargeable batteries.
Place the parent unit on the docking station and recharge for 10 hours before use.
4
The charging icon on the LCD will show the charging status.
5
Turn on the parent unit by pressing the POWER key (15) for 3 seconds.
6
The docking station will light red to show that the parent unit is securely docked on the station and
7
connection is good.
Turn off the parent unit by pressing the power key (15) for 5 seconds.
8
THE BABY UNIT:
The baby unit does not require batteries if powered from the electrical outlet.
1
If electrical outlet usage is not available, the baby unit will operate on batteries 4 x AA (LR6), which are not supplied.
2
To insert batteries, open the battery casing with a screwdriver. Insert 4 x AA (LR6) batteries (rechargeable
3
or non-rechargeable, but not mixed) and close casing securely with screwdriver. Take extra care to
ensure that the batteries are inserted correctly and the right way round.
There is NO charging function on the baby unit for rechargeable batteries.
4
The screen will illuminate on the baby unit when switched on.
5
The battery icons will indicate if the battery is low.
6
Battery power is disconnected automatically when the electrical adaptor is in use. If the adaptor is turned off at
7
the electrical outlet and still remains connected to the monitor then the batteries will be automatically activated.
8
When the baby unit is connected to the power supply, the LCD backlight will be on. With battery power
only, the LCD backlight will last only approx. 20 seconds.
9
Turn on the baby unit by pressing the POWER key (1).
WARNING about using the baby unit!
•
The baby unit should be 3.5 to 5 feet (1 to 1.5 meters) away from the baby's cot on a at surface.
•
Never place the baby unit in the baby's cot.
correct use of batteries
•
Non-rechargeable batteries are not to be recharged.
•
Rechargeable batteries are to be removed from the baby unit before being charged.
•
Rechargeable batteries are only to be charged under adult supervision.
•
Different types of batteries or new and used batteries are not to be mixed.
•
Only batteries of the same or equivalent type as recommended are to be used.
•
Batteries are to be inserted with the correct polarity.
•
Exhausted batteries are to be removed
from the monitor.
CAUTION: risk of severe malfunction if battery
•
is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
setting up your baby unit
Connect the electrical adaptor into a
1
nearby wall socket in your baby's
nursery and switch on the power
at the electrical outlet.
Press and hold (1) for 3 seconds
2
until the LCD/Power LED illuminates.
3
Ensure that the sensor pad on-off
switch (11) is turned OFF.
11
1
7
Publicité
