Mettler Toledo ICS241 Mode D'emploi page 41

None
Tare preset
ID1, ID2
Average PW
Dialog
Record number
Article name
Article number
Baud
Parity
Checksum
STX
Perform reset?
30232251A ICS241
Communication –> COM 1 –> Destination – Destination for barcode entry
Input destination is not predefined. The input will be shown on the display, you can
decide what to do with the input.
Input via barcode is assigned as tare preset.
Input via barcode is assigned as ID1 or ID2.
Input via barcode is assigned as average piece weight.
Bi-directional communication via MT-SICS commands, control of the device via PC.
Input via barcode is assigned as record number.
Input via barcode is assigned as article name. Then search the corresponding data in
material database
Input via barcode is assigned as article number. Then search the corresponding data in
material database.
Communication –> COM 1 –> Parameter – Communication parameters
Select baud rate.
Possible settings: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600,
115200.
Select parity.
Possible settings: 7 none, 8 none, 7 odd, 8 odd, 7 even, 8 even.
Activate/deactivate checksum byte.
Activate/deactivate STX.
If STX is enabled, the STX signal (0x02) is sent at the beginning of each output string
that is sent via the interface.
Communication –> COM 1 –> Reset COM x –
Reset communication settings to factory settings.
Confirmation inquiry.
• Reset the communication settings to factory settings with YES.
• Do not reset communication settings with NO.
41
Menu settings