Cristec YPOWER Série Manuel Utilisateur page 27

during and after its operation (burn hazard).
Precautions regarding dust, seepage and falling water
The regulator should be located so as to prevent
penetration of damp, liquid, salt and dust, any of which
could cause irreparable damage to the equipment and
be potentially hazardous for the user.
The appliance should be installed in a dry and well-
ventilated place.
Precautions regarding inflammable materials
The regulator should not be used near inflammable
materials, liquids or gases.
The batteries can emit explosive gases: please follow
the manufacturer's instructions carefully when
installing them.
Near the batteries: ventilate the area, do not smoke,
do not use any open flame.
Use fuses as defined in this manual.
The DC output fuses F1 and F2 should only be replaced
by the following blade fuse : Manufacturer : LITTLEFUSE
Reference : 287025 Rating :
Other precautions
Never attempt to drill or to machine the regulator's case:
this may damage components or cause metal chips or
filings to fall on the regulator's board.
Do not do anything that is not explicitly stated in this
32V-25A
25