Table des Matières
Publicité
Removing the Clean Water Tank
Fig.35
Replacing the Clean Water Tank
Fig.37
Replacing the Waste Water Tank
Fig.39
Regular Maintenance
Fig.36
Fig.37a
Fig.38
Fig.40
Once the clean-water tank has been emptied, the tank can be
removed.
Firstly detach the water feed pipe from the tap, this can be
done by pushing the red tap clip in whilst pulling off the pipe
(Fig.35).
The black suction hose from the
floor-tool simply pulls off the floor-tool
(Fig.36).
Inside the clean-water tank is a filter,
located below the clean-water inlet
(Fig.36a)
Clean all hoses and filters by flushing
Fig.36a
with clean water.
Fit the suction hose to the floor-tool (Fig.37) and pass through
the hole in the clean-water tank (Fig.37a).
Place the tank onto the machine base.
NOTE:
Ensure the water feed pipe locates in the channel
moulded into the base of the tank (Fig.38).
Fig.38a
Fig.39a
Refit the separator and reconnect the vacuum and suction
hose (Fig.40).
36
The water feed pipe simply
pushes onto the tap (Fig.38a).
Place the suction hose as shown
(Fig.39).
Place the tank onto the machine
(Fig.39a).
Publicité
Table des Matières
Dépannage
