Publicité
All manuals and user guides at all-guides.com
Submersible bilge pump with electronic switch
Submersible bilge pump for pumping bilge water in marine environment. To be
installed in the keelson.
Security
•
The pump may not be used for other liquid than water/bilge water.
•
Always install the pump according to wiring diagram, page 16.
•
Always use the fuse required, see Design features below.
•
The wire connections must be sealed with a marine sealant, e.g. vaseline, silicone
or grease.
•
Insulation or cable sheathings must be placed above the highest bilge water
level.
•
Do not run dry.
Operation
See illustration page 15.
A. When the bilge water rises the magnet float (1), it floats up and the air in the float
house (2) is forced out through the vent hole (3).
B. The magnet float starts the pump (4) when bilge water reaches 50 mm. The valve
(5) closes and the magnet float stays in the start position due to vacuum inside
the float house.
C. When the bilge water has sunk to level 20 mm, air is let in through the air opening (6)
in the float house. The magnet float falls down and cuts off the power.
Type designation Cartridge Combo
Pumptype
500 GPH-12V
Part No EU
32-05503-00
Part No US
05503-00
Design features
Hose size
Capacity, straight
(13.6 V)
Capacity, 0,9 m head
(13.6 V)
Voltage
Amperage
Fuse size
Height
Weight
Body
Shaft
Shaft seal
Wire size
Original instructions
750 GPH-12V
1000 GPH-12V
32-05703-00
32-05903-00
05703-00
05903-00
500 GPH
750 GPH
¾"
¾"
40 l/min/
50 l/min/
630 GPH
800 GPH
33 l/min/
44 l/min/
525 GPH
700 GPH
12 V DC
12 V DC
2,5 A
3 A
5 A
5 A
112 mm
112 mm
0.40 kg
0.40 kg
Thermoplastic
Thermoplastic
Stainless steel Stainless steel Stainless steel Stainless steel
Lip seal
Lip seal
0.75 mm
0.75 mm
2
16 GA
16 GA
Bilge Pump Cartridge Combo- Instruction Manual
1250 GPH- 12V
32-06203-00
06203-00
1000 GPH
¾"
63 l/min/
1000 GPH
50 l/min/
800 GPH
12 V DC
3.2 A
5 A
112 mm
0.40 kg
Thermoplastic
Lip seal
0.75 mm
2
2
16 GA
> English
1250 GPH
1⅛"
73 l/min/
1150 GPH
60 l/min/
952 GPH
12 V DC
3 A
5 A
112 mm
0,40 kg
Thermoplastic
Lip seal
1.3 mm
2
16 GA
5
Publicité
