Clarke American Sanders OBS-18DC HDTR Manuel De L'utilisateur page 5

Machine Setup
To prepare the machine for use follow this procedure:
1. Familiarize yourself with the machine. Read all danger,
warning, and caution statements and the Operation and Parts
Manual before operating the machine. If you or the operator
are unable to read English, have this manual fully explained
before attempting to operate this machine.
2. Install or replace pad. The pad should be replaced if it has
become matted down to a thickness of 3/8" or less. To install
or replace the pad, follow these instructions:
a.) Lock handle in the upright position.
b.) Tilt the machine back until it fully rests on the handle.
c.) Standing over the machine, remove existing pad then
center new pad over grip face.
d.) Press pad against grip face until the hooks in the driver
have set in the pad. See figure 3.
e.) Return machine to the upright position.
CAUTION:
Damage to the grip face will occur if the
machine is operated without a pad or with a
pad that is 3/8" or thinner.
WARNING: Never put yourself or let others be in a posi-
tion to get injured if the machine should tip
or fall, while replacing the pad or changing
abrasive.
®
Clarke
American Sanders Operator's Manual (EN) - OBS-18/18DC HDTR
ENGLISH
EN
Figure 3
- 5 -