FLAT ROOF MOTOR WD206BD
Assembly
Connection diagram
1. Determine positioning.
2. Saw or drill hole of the desired diameter.
3. Use supplied piping items to mount motor or culvert to existing
bitumen (glue if necessary).
4. Paste or melt new bitumen across the stainless steel plate,
preferably a few centimetres up the edge (rising edge of 80mm).
5. Connect cables and/or ducting.
6. Any gaps that appear in the insulation should be sealed with foam.
Recommended: the arrow on the non-return value needs to point in
the waste air direction.
Please note: NEVER switch the covers!!!
Black
(230V)
Blue
(null voltage)
Yellow/Green
(earth)
Red
(PWM)
Wit
(PWM)
Connector has position indication
Numbering of the 5-core cable
Black
(230V)
Blue
(null voltage)
Yellow/Green
(earth)
Red
(PWM)
Wit
(PWM)
EN 9