Publicité
INSTALLATION AND POWER
SUPPLY
CAUTION:
● Be careful not to pinch your fingers when opening
and closing the battery cover.
● Return the battery compartment locker to the
original position, after installing or removing
battery cartridge. If not, battery cartridge may
accidentally fall out of the speaker, causing injury
to you or someone around you.
● Always close and lock the battery compartment
locker before moving the speaker.
● Always switch off the speaker before installing or
removing the battery cartridge.
● Be careful not to drop or strike the speaker.
Broken shell may slash your finger or stab your
body. Damaged speaker may exhibit unpredictable
behavior resulting in fire, explosion or risk of
injury.
● Hold the speaker and the battery cartridge firmly
when installing or removing battery cartridge.
Failure to hold the speaker and the battery
cartridge firmly may cause them to slip off your
hands and result in damage to the speaker and
battery cartridge and a personal injury.
IMPORTANT:
● Reduced power, distortion, "stuttering sound" or a low
battery icon appearing on the display are all signs that
the main battery pack needs to be replaced.
● The battery cartridge can't be charged via the supplied
AC power adaptor.
● The battery cartridge is not included as standard
accessories.
Installing or removing slide battery
cartridge (Fig. 2-4)
● To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click.
● If you can see the red indicator on the upper side of
the button, it is not locked completely. Install it fully
until the red indicator cannot be seen. If not, it may
accidentally fall out of the speaker, causing injury to
you or someone around you.
● Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
● To remove the battery cartridge, sliding it from the
speaker while pressing the button on the front of the
cartridge.
Indicating the remaining battery
capacity (Fig. 5-6)
Only for battery cartridges with the indicator
1. Indicator lamps
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light
up for few seconds.
● XGT/LXT battery cartridge
Indicator or lamps
Lighted
NOTE:
● Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
● The first (far left) indicator lamp will brink when the
battery protection system works.
● When the battery power is low, please replace the
battery.
Using supplied AC power adaptor
Remove the rubber protector and insert the adaptor
plug into the DC socket on the right hand side of the
speaker. Plug the adaptor into a standard mains socket
outlet. Whenever the adaptor is used, the battery pack is
automatically disconnected.
CAUTION:
● Always disconnect the AC power adaptor
completely before moving the speaker. If the AC
adaptor is not removed, it may cause an electric
shock.
● Never pull and/or drag the cord of the adaptor.
If not, the speaker may accidentally fall down,
causing injury to you or someone around you.
IMPORTANT:
● In order to disconnect the speaker, the mains adaptor
should be removed from the mains outlet completely.
8 ENGLISH
2. Check button
Remaining capacity
Off
Blinking
Charge the battery
The battery may have
75% ~ 100%
50% ~ 75%
25% ~ 50%
0% ~ 25%
malfunctioned
Publicité
