LIVARNO LUX HG04857A Instructions De Montage, D'utilisation Et Consignes De Sécurité page 10

Mounting the solar cell
Make sure you will not be drilling into electrical,
gas or water lines inside the wall. Use a power
drill to drill the holes into the brick wall. Always
observe all safety instructions for the power drill
in the manual for the power drill. Death or injury
due to electric shock may otherwise result.
When selecting the mounting location for the
solar cell , pay attention to the following:
12
The solar cell
12
exposed to sunlight as possible. Even partial
shading of the solar cell
can have a significant influence on charging.
Cardinal direction:
Orientation towards the south is optimum. Ori-
entations with slight deviations towards the west
are preferable to those with slight deviations
towards the east.
Horizontal orientation:
The horizontal orientation of the solar cell
depends on the geographic latitude of the
mounting location. In central Europe, and angle
of 30°–40° is ideal.
A mounting plate with 6 drill holes for screws is
located at the back of solar cell
Mount the solar cell
location using the 4 small screws
dowels . Depending on the topography of
15
the mounting location, you can freely choose
4 of the drill holes in the mounting plate;
however, you should ideally select 2 drill
holes on the right and left each (see fig. B).
Then lay the solar cable plug
nect the plug to the solar electricity socket
of the spotlight
8
10 GB/IE/NI
needs to be as directly
during the day
12
12
.
12
at the designated
12
and
13
and con-
14
.
10
The solar cell is originally connected to
12
the mounting plate via a swivel joint. Orient
the solar cell in a manner that ensures
12
maximum exposure to sunlight.
Preparing the product
for use
Switching the motion
detector on and off
Press the ON / OFF switch
position to switch on the motion detector
the red LED indicator of ON / OFF switch
lights on at the same time.
Press the ON / OFF switch
position to switch off the motion detector
the red LED indicator of ON / OFF switch
extinguish at the same time.
Setting the lighting duration
Turn the rotary control TIME
bottom of the motion detector
to increase the duration of the illumination
(see Fig. C). The lighting duration can be
adjusted within a time window of approx.
5s +/-2s to 5 min +/-1min.
Adjusting the sensitivity of
the sensor
Turn the rotary control SENS
bottom of the motion detector
to increase the sensitivity of the sensor (see
Fig. C).
into the ON
11
;
9
11
into the OFF
11
;
9
11
on the
19
clockwise
9
on the
18
clockwise
9