Publicité
1.
Attach Upper Mounting Bracket
F1
P6
P3
P1. Left Side Panel
P3. Right Side Panel
P4. Shelf
P5. Top Panel
P6. Upper Bracket
F1. 5/16" Allen-head bolt
Working from the back with the mounting bracket rims pointing
down, align the two holes in each corner of the upper
GearTrack
/GearWall
bracket (P6) with the two holes in each
®
®
corner of the top panel (P5). Insert four Allen-head bolts (F1)
through the upper GearTrack
top panel (P5). Completely tighten the bolts.
3.
Mount on GearWall
GearTrack
Channels
®
A
B
A. Bracket rim
B. Slot
C. Mounting bracket fully engaged
Determine workstation mounting location on GearWall
or GearTrack
channels. Using two or more people, engage the
®
mounting brackets into the wall slots by lifting up, pushing toward
the wall and lowering the bracket rims into the slots. Inspect the
workstation from the sides to ensure the wall mounting bracket is
fully engaged in slots as shown.
NOTE: The lower bracket slots allow for adjustments in
GearTrack
System or GearWall
®
P5
P4
/GearWall
bracket (P6) and into the
®
®
Panels or
®
C
panels
®
variation.
®
2.
Attach Lower Mounting Bracket
F1
P7
P1
P1. Left Side Panel
P2. Bottom Panel
P3. Right Side Panel
P4. Shelf
P7. Lower Bracket
F1. 5/16" Allen-head Bolt
Working from the back with the mounting bracket rims pointing
down, align the two slots in each side of the lower
GearTrack
/GearWall
®
side panels (P1 and P3). Insert four Allen-head bolts (F1) through
the bracket (P7) and into the side panels (P1 and P3). Make sure
the distance from the top of the upper bracket to the top of the
lower bracket measures 24" (60.96 cm) on both sides. Completely
tighten the bolts.
WORKSTATION
INSTALLATION:
Mounted directly to a wall
Tools and Parts Needed:
Socket wrench with 2" extension
Ƀ
1/2" Socket wrench
Ƀ
5/16" x 1½" Lag screws (6)
Ƀ
5/16" Flat washers (6)
Ƀ
IMPORTANT: The holes in the top panel (P5) and the bottom
panel (P2) are spaced to allow you to mount the workstation to
your garage wall studs.
Locate the wood studs in your garage wall. Align three holes
Ƀ
at the top and three holes at the bottom with the wood studs,
and mark the location of the holes.
While two or more people hold the workstation against the
Ƀ
wall, attach the workstation to the garage wall using 5/16" flat
washers and 5/16" x 1½" lag screws (not provided).
Use a 1/2" socket wrench to fully tighten the screws.
Ƀ
P3
P3
bracket (P7) with the slots in each of the
®
ALTERNATE
A
P4
P2
A
A. Holes for standard wall mounting
P4
P1
P2
P5
P1
7
Publicité
