Publicité
3.
Workstation Top
F1
P1
P1. Left Side Panel
P2. Bottom Panel
P3. Right Side Panel
P4. Shelf
P5. Top Panel
F1. 5/16" Allen-head bolt
Insert the top panel (P5), between the edges of the sides
(P1 and P3) and align the holes.
Attach the top panel (P5) to both the side panels (P1 and P3).
If Mounting to Standard Wall
Use six Allen-head bolts per side to attach the top panel (P5)
Ƀ
to the side panels (P1 and P3). Do not fully tighten the bolts.
If Mounting to Gladiator
GearWall
®
channels
Omit the four bolts attaching the back corners. Use four Allen-
Ƀ
head bolts per side, as shown. Do not fully tighten the bolts.
NOTE: The back of the top panel (P5) will be fastened to the side
panels (P1 and P3) when the upper GearTrack
(P6) is attached.
6
F1
F1
P5
P4
F1
P2
P3
panels or GearTrack
®
®
/GearWall
®
bracket
4.
Square Workstation Frame
P1
P1. Left Side Panel
P2. Bottom Panel
P3. Right Side Panel
P4. Shelf
P5. Top Panel
The measurements from corner to corner should be equal
distance. Use the Allen wrench (provided) to fully tighten the
bolts. Measure the frame again to make sure it is still square.
INSTALLATION
®
INSTRUCTIONS
Use two or more people to move shelving.
Failure to do so can result in back or other injury.
IMPORTANT: Decide if you are going to install the workstation
on Gladiator
GearWall
®
standard garage wall. Follow the instructions for your installation.
Install Workstation to GearWall
Panels or GearTrack
IMPORTANT:
Be sure the GearWall
Ƀ
installed with mounting screws in every slot and at every
stud location with a maximum of 24" (60.96 cm) horizontally
between screws.
If installing the workstation on GearTrack
Ƀ
use two channels installed 18" (46 cm) apart.
18" (46 cm)
P5
P4
P2
WARNING
Excessive Weight Hazard
panels or GearTrack
®
®
Channels
®
panels or GearTrack
®
®
P3
channels, or on a
®
channels are
®
channel, you must
Publicité
