Publicité
!
!
!
Prepare and
clean the
lock recess
Connect the cable
EN
56
Assembly
Warning!
Risk of death due to electric shock: Incorrect wiring is life-threatening.
· Only allow a qualified, skilled electrician to connect the electricity supply.
Caution!
Risk of injury caused by sharp edges and metal filings: Drilling and other machining operations can cre-
ate sharp edges and metal filings which may cause injury.
· Always particularly protect your eyes with suitable protective goggles.
Preparing for assembly
Caution!
Unsuitable doors impair personal protection and burglary protection: Only approved and technically
flawless doors are suitable for installing the lock.
· Before installing the lock, check that the door is properly fitted and is not warped.
· Check that the door is approved for use with the lock.
1
Create the lock recess at a suitable vertical installation position in the door leaf. Allow for an extra
30-mm depth for the cable loop.
2
Create the drill holes for the fixing screws as in line with Fig. 14 and Fig. 15.
3
Drill the holes for the lock fittings (only with the lock removed).
4
Clean the lock recess and all drill holes by blowing out or vacuuming.
Electrical connection
1
Prepare the wiring for the lock
("Electrical connection", page 60).
2
Connect the power supply and control cables
("Flexible cable transition", page 70).
Assembly
Publicité
