Publicité
Assembly
Warning!
!
Inspect for damage: Damage to cables can lead to electric shock. Damage to metal parts can lead to
injuries. A damaged lock is a safety risk.
· Never put a damaged device into operation. Never use damaged cables or plug connections.
· Always inspect the packaging and the lock for damage.
Always comply with local building regulations and provisions: Always comply with all building regula-
tions when assembling the lock and electrical connection. Comply with the instructions of the door manu-
facturer.
A
At tention!
Material damage caused by working on the door leaf: Dismantle and remove the lock when working on
the door leaf, for example when drilling or milling.
· Only use the factory-made drill holes for attaching the door fittings
· Dismantle and remove the lock before working on the door leaf, for example when drilling or milling.
Functional impairment caused by faulty milling of the lock recess: It must be possible to insert the lock
without force and screw it in place without distortion.
· Mill the lock recess according to the lock case dimensions.
Damage caused by dirt: Contamination damages the lock.
· Clean the lock recess and all drill holes by blowing out or vacuuming before installation.
Impaired function caused by distorted installation: All bolts must be able to close without transverse
loading.
· Install the lock, all bolts and accessories (strike plate, fittings, lever handle) without distortion.
Material damage caused by forced insertion of the latch pin into the lock follower: It must be possible
to simply push the latch pin of the door handle into the lock follower.
· Do not use any tools to push the latch pin into the lock follower.
Impaired function caused by door handle not moving freely: Install the lock so that the latch pin and
the lock follower are aligned.
Danger of destruction by construction key: Using a construction key can destroy the lock. The lock func-
tion is then no longer guaranteed.
· Use a suitable locking cylinder to operate the lock.
Comply with the power supply tolerances: Exceeding or falling below the tolerance limits will cause
damage and malfunction.
· Measure the lock to verify that the operating voltage is within the stated tolerance limits during nominal
current consumption.
EN
54
Assembly
Publicité
