Scope Of Delivery; Parts Overview - Bresser TemeoTrend Sunny Mode D'emploi

RISK OF FIRE/EXPLOSION!
Use only the recommended batteries. Do not short-
circuit the device or batteries, or throw them into
a fire. Excessive heat or improper handling could
trigger a short-circuit, a fire or an explosion.
NOTE!
Do not disassemble the device. In the event of a
defect, please contact your dealer. The dealer will
contact the Service Centre and can send the device
in to be repaired, if necessary.
Do not immerse the unit in water.
Do not subject the unit to excessive force, shock,
dust, extreme temperature or high humidity, which
may result in malfunction, shorter electronic life
span, damaged batteries and distorted parts.
Use only the recommended batteries. Always
replace weak or empty batteries with a new,
complete set of batteries at full capacity. Do not
use batteries from different brands or with different
capacities. Remove the batteries from the unit if it
has not been used for a long time.
The manufacturer is not liable for damage related to
improperly installed batteries!
12

SCOPE OF DELIVERY

Main unit (A), table stand for main unit (B), remote
sensor (C), instruction manual
Required batteries (not included with purchase): 5
pieces of micro batteries (1.5V, type AAA)

PARTS OVERVIEW

Main Unit (Fig. 2)
(1) Display – The display facilitates easy reading
of weather forecast, indoor humidity, indoor and
outdoor temperature, current time, and date.
(2) DOWN button – The 'down' button decreases
the value of a setting. Toggle between °C and
°F. Press and hold for 2 seconds to set values
for highest and deepest temperature alert.
(3) UP button – The 'up' button increases the
value of a setting. Allows to switch between MIN
and MAX values. Press and hold for 2 seconds
to initialize receiving DCF77 RC signal.
(4) SET button – The 'set' button enters the
setting mode for time and date.
(5) ALARM button – The 'alarm' button enters the
setting mode for alarm time.
(6) CHANNEL button – Press 'channel'
repeatedly to successively display the
temperature information of the different remote
sensors (optional: up to 3 outdoor sensors
can be connected). Press and hold for 2
seconds to initialize transmission of the RC
signal from the remote sensor.
(7) SNOOZE/LIGHT button – Press this button
to turn on the background lighting or to
interrupt the alarm.
(Fig. 1)