Publicité
Each day of use:
Clean the bar and check for wear and damage. Feathering
or burring of the bar rails is a normal process of bar wear,
but such faults should be smoothed with a file as soon as
they occur.
Each week of use:
Reverse the guide bar on the saw to distribute the wear.
Lubricate the sprocket at the end of the guide bar using
a grease syringe in the lubricating hole.
Turn the guide bar and check that the lubrication holes
and chain groove are free from impurities.
A bar with any of the following faults should be replaced
immediately:
Wear inside the bar rails that permits the chain to lay over
sideways
Bent guide bar
Cracked or broken rails
Spread rails
TRANSPORTING AND STORING
See Figure 30.
WARNING:
Make sure the switch trigger is locked out in the off
position and the chain has stopped before transporting
or storing pruning saw. Place pruning saw indoors in a
dry, secure location out of the reach of children when
storing. Failure to follow these instructions may lead to
accidental starting or unauthorized use and result in seri-
ous personal injury.
Do not store or transport the pruning saw when it is
running. The pruning saw should always be idle before
storing or transporting.
Always place the guide bar scabbard on the bar and
chain before storing or transporting the pruning saw. Use
caution to avoid the sharp teeth of the chain.
Store pruning saw on its side.
Clean the pruning saw thoroughly before storing. Store
the pruning saw indoors, in a dry place that is locked and/
or inaccessible to children.
Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
BATTERIES
This product is equipped with a lithium-ion rechargeable
battery. Length of service from each charging will depend
on the type of work you are doing.
MAINTENANCE
The battery in this product has been designed to provide
maximum trouble-free life. However, like all batteries, it will
eventually wear out.
To obtain the longest possible battery life, we suggest
the following:
Remove the charging cable from the product once it is
fully charged and ready for use.
For product storage longer than 30 days:
Store the product where the temperature is below 80°F
and away from moisture.
Store product in a 30%-50% charged condition.
Every six months of storage, charge the product as normal.
BATTERY PACK REMOVAL AND
PREPARATION FOR RECYCLING
Drain the battery by running the tool until it shuts off.
Look for the Phillips head screws near the charging port
to locate the battery compartment door.
Unscrew the screws and remove the battery compartment
door.
Pull the battery out of the tool and separate it from the
two wire connectors.
Apply tape over the ends of the wire connectors for bat-
tery disposal.
To preserve natural resources, please recycle or dispose of
batteries properly.
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Lithium-ion batteries must be recycled or disposed
of properly. Also, never touch both terminals with metal
objects and/or body parts as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
Page 16 — English
This product contains lithium-ion batteries.
Local, state or federal laws may prohibit dis-
posal of batteries in ordinary trash.
Consult your local waste authority for infor-
mation regarding available recycling and/or
disposal options.
WARNING:
Publicité
