Publicité
Maintenance & Care
Replacing the Water filter
Some models will come with an optional water filter:
it is recommended to fill your unit with distilled
water only. it is essential to check the filter and
replace it when it is no longer effective. Change
the filter when the green grains turn blue.
if the filter is not changed at the appropriate
time, calcium deposits may accumulate on the
heater, causing damage or reduced performance.
To replace the filter:
1. Using the grips on the side of the filter, pull
filter out of the unit.
2. Push filter firmly into the machine until
it's flush.
Reference page 11 for replacement part
information.
cleaning hose tube
1. Grab bottom end of the hose and pull
lower portion away from the body.
2. seperate the hose into two pieces.
3. Wash hose.
4. Align the top of the hose to the groves
on the hose opening of the unit.
5. Twist hose down to insert lower portion
of hose to the unit.
6. Make sure hose fits tightly into the unit.
cleaning foot of Unit
1. To clean the foot and bristles, push the release
button on the back of the pivot joint and pull the
foot to release it from the appliance.
2. Wash bottom of foot and bristles with
cold water.
notE: make sure foot and bristles are dry
before attaching the foot to the appliance.
3. To re-attach the foot to the appliance: place
the foot on the floor, push the appliance down
into the foot and then listen for the click that
sounds when properly attached.
WaRnInG
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
1.
5.
2.
3.
6.
9
Publicité
