REMOTE CONTROLLER
Power
Number Keypad
Menu
Arrows/Enter
Title
Volume
Stop
DVD/USB
OSD
L/R
L/R
N/P
Search
VOL + : Press to INCREASE the volume.
VOL - : Press to DECREASE the volume.
SKIP PREV - Press to return to the previous title, chapter, or track.
SKIP NEXT - Press to skip to the next title, chapter, or track.
STOP - Press to stop a DVD or CD during play.
PLAY/PAUSE - Press to play or pause a loaded disc .
DVD/USB - To select between DVD and USB.
OSD - Press to view the various On Screen Display modes.
WIDE - Press to switch between different aspect ratio settings.
ZOOM - Press to zoom in or out of a picture on the screen.
L/R - Press to switch between the Left and Right audio channels.
N/P - Press to select between NTSC and PAL output signal.
SLOW - Press to view the loaded DVD in slow motion.
REPEAT - Press to enable repeat play of track or tracks.
SEARCH REV - Press to scan backward. Press again to increase scan speed ( 2x, 4x, 8x, 16x, 32x).
SEARCH FWD - Press to scan forward. Press again to increase scan speed ( 2x, 4x, 8x, 16x, 32x).
STEP - Press to advance one frame at a time.
Open/Close
Mute
Audio
Goto
Prog
Angle
Setup
Subtitle
Skip
Play/Pause
Zoom
Wide
Repeat
Slow
A-B
A-B
Step
6
POWER - Press to turn the power On/Off or
restore the DVD player to standby mode.
OPEN/CLOSE - Press to open and close the disc
drawer.
MUTE - Press to mute or unmute the volume.
NUMBER KEYS - Input numbers when in
Program mode.
AUDIO - Press to change the audio settings.
GOTO - Go to a specific title, chapter, or play time/
point on a DVD.
PROGRAM- Press to program a DVD to play
chapters or tracks in a specified order.
ANGLE - Press to access different camera
angles on supported DVDs.
MENU - Open the main menu.
SETUP - Press to access or exit the setup menu.
ARROWS UP/RIGHT/LEFT/DOWN - Press directional
buttons to navigate through menu screens.
ENTER - Press to confirm selections within on-
screen menus or the setup menu.
TITLE - Press to access the title menu of a
loaded DVD.
SUBTITLE - Press to turn available subtitles on
or off.
INSTALLATION OF BATTERIES
1. Press and lift the back cover up to open
the battery compartment of the remote
control.
2. Insert two AAA size batteries. Make sure
that the polarities of the batteries ( + )
and ( - ) match those of the battery
compartment.
3. Close the battery compartment cover.