Publicité
▪
Push the Lock-Off (2) button and press throttle trigger (1) to run.
NOTE: If engine fails to start after repeated attempts, refer to Troubleshooting section.
NOTE: Always pull starter rope straight out. Pulling starter at an angle will cause rope
to rub against the eyelet. This friction will cause the rope to fray and wear more
quickly. Always hold starter handle when rope retracts. Never let a rope snap back
from extended position. This could cause rope to snag or fray and also damage the
starter assembly.
10.2
Stopping the engine (Fig. 11)
10.2.1
Emergency STOPPING Procedure
When it is necessary to stop blower engine immediately, PRESS the OFF"STOP
10.2.2
Normal Stopping Method.
For normal stopping, release trigger (1) and allow engine to return to idle speed. Then PRESS the
OFF "STOP
" switch (3).
10.3
Starting a warm engine (Engine stopped for no more than 15-20minutes) (Fig.8 &10)
▪
Make sure ignition switch (3) is in the ON (I) position, pull the starter rope (5) briskly.
▪
If engine does not start, or starts and then stops after 5 rope pulls, follow procedure "STARTING A
COLD-engine".
10.4
Blower operations
▪
Use the blower for trees, shrubs, flower beds, and hard-to-clean areas.
▪
Use the unit around buildings and for other normal cleaning procedures.
▪
Use the blower around walls, overhangs, fences, and screens.
WARING: Wear clothes fitting, tough work clothing that will provide protection. Such
as heavy long pants, safety work shoes, heavy duty work gloves, hard hat, a safety
face shield, or safety glasses for eyes protection and ear plugs for hearing protection.
WARNING: Keep children, bystander, and animals 50 feet (15m) away. If approached
stop unit immediately.
WARNING: When using the unit, basic safety precaution, should always be followed
to reduce the risk or serious personal injury and damage to the unit.
▪
We recommend that a face mask be worn when operating blower in dusty areas.
▪
Stand away from the debris, at a distance that will easily allow you to control the direction of blown
debris. Never blow debris in direction of bystanders.
▪
To control velocity of air stream, blower can be operated at any speed between idle and full
throttle.
▪
experience with the unit will help you determine the amount of airflow necessary for each
application.
▪
To reduce sound levels, limit the number of pieces of equipment used at any one time .
▪
Check your equipment before operation, especially the muffler, air intakes and air filters.
Copyright © 2021 VARO
POWEG9020
P a g e
| 9
EN
" switch(3).
www.varo.com
Publicité
