Publicité
9.2
Mixing fuel
Add oil to an approved fuel container followed by the gasoline to allow incoming gasoline to mix with
oil. Shake container to ensure thorough mix.
Warning: Lack of lubrication voids engine warranty. Gasoline and oil must be mixed
at 30:1.
9.2.1
Fuel and lubrication symbols
9.2.2
Fuel and lubrication symbols
GASOLINE
Mixing Ratio
9.2.3
Recommended fuels
Some conventional gasolines are being blended with oxygenates such as alcohol or an ether
compound to meet clean air standards. The engine is designed to operate satisfactorily on any
gasoline for automotive use including oxygenated gasolines.
10
OPERATING INSTRUCTIONS
10.1
Starting a cold engine (Fig.8,9 & 10)
▪
Make sure ignition switch (3) is in the ON (I) position.
▪
Pump primer bulb (12) 6 times by pressing up on the bulb (12).
▪
Your unit is designed with a 2 position choke (8) : FULL CHOKE
▪
With the unit on the ground, hold the top assist handle (4) and step on the top of the frame with
your foot.
▪
Position the choke lever (8) to full choke
the engine turn over to begin to start, than position choke to Run
until the unit starts.
Copyright © 2021 VARO
30:1
30 parts Gasoline to 1 Part Lubricant
POWEG9020
and pull starter handle (5) 2-3 times until you hear
P a g e
| 8
,and RUN
.
and pull 3-4 more times
www.varo.com
EN
Publicité
