Zipper Maschinen ZI-GRM400 Manuel D'utilisation page 23

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-GRM400 | ZI-GRM1100 | ZI-GRM1650
3. Slide a wheel followed by a
washer onto one of the two axle
brackets and secure with a cotter
pin. Repeat procedure on the
opposite side to mount the second
wheel.
4. Take the motor/feather pan unit
out of the polystyrene mould now
and place it upright on its legs.
5. Remove the finger plate from the
tub. Mount rubber finger into the
opening on the underside of the
finger plate.
ASSEMBLY
23