Assembly; Assembly Zi-Grm400 - Zipper Maschinen ZI-GRM400 Manuel D'utilisation

12

ASSEMBLY

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please understand
that later claims cannot be accepted anymore.

12.1 Assembly ZI-GRM400

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-GRM400 | ZI-GRM1100 | ZI-GRM1650
1. Unpack the machine as shown in the
illustration on the left: Open the
cardboard box, remove the polystyrene
cover and place it upside down on a
flat surface in your assembly area.
Remove the motor / feather pan unit
and place it in the polystyrene mould
with the shaft pointing downwards
(motor pointing upwards; shaft should
be placed in the hole in the polystyrene
mould).
NOTE: Each leg fits only for one
position. The legs and axle brackets are
marked A, B and C at the factory for
easier mounting!
2. Attach the legs to the motor / feather
pan unit. Mount the leg marked A into
the axle mount marked A etc.
ASSEMBLY
22