Publicité
Les langues disponibles
Les langues disponibles
EN
If the battery pack cracks or breaks, with or without
leaks, do not recharge it and do not use. Discard it
and replace with a new battery pack. DO NOT TRY
TO REPAIR IT! To prevent injury and risk of fire,
explosion, or electric shock, and to avoid damage to
the environment:
•
Cover the terminals of the battery with heavy-duty
adhesive tape.
•
DO NOT try to remove or destroy any of the
battery pack components.
•
DO NOT try to open the battery pack.
•
If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
•
DO NOT put these batteries in your regular
household trash.
•
DO NOT incinerate.
•
DO NOT put them where they will become part of
any waste landfill or municipal solid waste stream.
•
Take them to a certified recycling or disposal
center.
7
PROPOSITION 65
This product contains a chemical known to the
state of California to cause cancer, birth defects
or other reproductive harm. Some dust created by
power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
•
Lead from lead-based paints;
•
Crystalline silica from bricks and cement and other
masonry products;
•
Arsenic and chromium from chemically treated
lumber.
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a
well-ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
Save these instructions.
8
INSTALLATION
Do not change or make accessories that are not
recommended by the manufacturer.
WARNING
WARNING
WARNING
English
Do not install battery pack until you assemble all the
parts.
8.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
•
If the parts are damaged, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
8.2
ADD THE BAR AND CHAIN OIL
Examine the amount of oil in the machine. If the oil level
is low, add the bar and chain oil as follows.
Use bar and chain oil that is only for chains and chain
oilers.
The machine comes from the factory without bar and
chain oil.
1. Loosen and remove the cap (6) from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator (7) to make sure that no dirt
gets into the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for approximately 20- 40
minutes.
8
WARNING
WARNING
WARNING
IMPORTANT
NOTE
6 7
Publicité
