Publicité
Les langues disponibles
Les langues disponibles
EMPTYING THE DUST CUP
IMPORTANT: Unplug the power cord before performing any maintenance.
To remove Dust Cup, pull up on the release
button located on the side of dust cup handle.
Tilt dust cup forward, then lift to remove.
To remove collected debris from Lint Screen,
lift the tab at the top of the dust cup to
open the lid. Remove debris from lint screen
to clean.
s h a r kc l e a n . c o m
Hold the dust cup over the waste bin and press
the release button to open bottom of dust cup.
To reinstall, place the bottom of dust cup
onto the pod and then tilt until it clicks into
place.
CLEANING THE FILTERS
Regularly rinse the filters to maintain your vacuum's suction power.
Rinse filters with cold water only. Allow all filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being drawn into electronic parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam
Felt
RINSE PRE-MOTOR FILTERS
EVERY MONTH
Remove Dust Cup, then lift out Filters.
NOTE: The pre-motor filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
Post-Motor
Filter
HEPA Filter
Door
RINSE HEPA FILTER
EVERY YEAR
To remove the HEPA Filter, first pull the tab
on the bottom of the filter door, then lift off
the door. Press the tab on the left side of the
HEPA filter and pull out the filter.
To reinstall the HEPA filter, insert the right
side of filter first. Push tab on the left side of
the HEPA filter in until it clicks into place.
To reinstall the door, align the top first, then
press in the bottom until it clicks into place.
s h a r kc l e a n . c o m
Publicité
