Powerplus POWXG1032 Mode D'emploi page 57

10 INSTRUCTIONS FOR CUTTING
See fig 1
10.1 Tree logging
See fig 2
10.2 Branches removal
See fig 3
10.3 Trunk trimming
See fig 4
Second and third picture are ways to prevent blocking of the chain and blade.
11 STARTING UP THE MACHINE
See fig 5
Stop the tool and unplug the power plug before performing any cleaning,
inspection, maintenance or other works on the tool.
Never attach the strap diagonally across your shoulder and your breast, but
rather place it on one of your shoulders. In this way you can remove the tool
quickly from your body in case of danger.
Disconnect your gardening tool from the power supply.
After adjustment make sure that the angle adjustment buttons have returned
to their initial positions. Otherwise the tool cannot start.
Do not connect to power supply until assembly is complete, Failure to
comply could result in accidental starting and possible serious personal
injury.
11.1 Assembly of chain bar and chain
See fig 6
Repeat tensioning of new chain after approx. 5 cuts. Check chain tensioning regularly.
Note: the saw chain may droop slightly on the lower part of bar. This is normal.
Note: the guide bar retaining nuts are installed only hand tight at this point because saw chain
adjustment is required. Follow instructions in section saw chain tension adjustment.
Warning: always wear heavy duty gloves when handling saw chain or
making saw chain adjustments
Copyright © 2022 VARO
POWXG1032
P a g e | 9
EN
www.varo.com