Bostitch SB-150SLBC Manuel D'instructions Et D'entretien page 4

TOOL SPECIFICATIONS
All screws and nuts are metric
TOOL
MODEL
ACTUATION
SB150SLBC-1 Contact Trip
SB150SLBC-2 Sequential Trip
Cap Capacity: 100 Caps
Staple Capacity: 150 Staples
FASTENER SPECIFICATIONS:
STAPLE SERIES
SL5035
TOOL AIR FITTING:
This tool uses a free-flow connector plug, 1/4 N.P.T. The inside diameter should be .200" (5mm) or larger.
The fitting must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.8 to 6.9 Bar ). Select the operating pressure within this range for best fastener
performance.
DO NOT EXCEED THE RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The SB150SLBC requires 5.63 cubic feet per minute (.16 cubic meters) of free air to operate at the rate of
100 staples per minute, at 90 p.s.i. (6.2 Bar). Take the actual rate at which the tool will be run to determine the
amount of air required. For instance, if your fastener usage averages 50 staples per minute, you need 50% of
the tool's c.f.m. which is required to operate the tool at 100 staples per minute.
OPERATION
BOSTITCH offers two types of Operation for this series tool.
CONTACT TRIP
The common operating procedure on "Contact Trip" tools is for the operator to contact the work to
actuate the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work
is contacted. This will allow rapid fastener placement in many industrial applications.
All pneumatic tools are subject to recoil when driving fasteners. The tool may bounce, releasing the
trip, and if unintentionally allowed to recontact the work surface with the trigger still actuated (finger still
holding trigger pulled) an unwanted second fastener will be driven.
SEQUENTIAL TRIP
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This
makes accurate fastener placement easier, for instance on finish applications.
The Sequential Trip allows exact fastener location without the possibility of driving a second fastener on
recoil, as described under "Contact Trip".
The Sequential Trip Tool has a positive safety advantage because it will not accidentally drive a fastener if
the tool is contacted against the work – or anything else – while the operator is holding the trigger pulled.
MODEL IDENTIFICATION:
Refer to Operation Instructions on page 8 before proceeding to use this tool.
CONTACT TRIP
Identified by:
BLACK TRIGGER
LENGTH
11.25" (285.8mm)
11.25" (285.8mm)
CROWN WIDTH
5/16" (8.0mm) .050 x .035 (1.27 x 0.89mm)
SEQUENTIAL TRIP
Identified by:
GRAY TRIGGER
HEIGHT
10.63" (270.0mm) 6.38" (162.1mm)
10.63" (270.0mm) 6.38" (162.1mm)
WIRE GAUGE
4
WIDTH WEIGHT
4.7 lb (2.1 kg)
4.7 lb (2.1 kg)
FASTENER RANGE
3/4"-11/2" (19mm-38mm)