essentiel b ECFV1 Notice D'utilisation page 8

Description of the control panel
(programmable coffee makers only)
4
7
5
1. Coffee machine on/off key
2. Red light for the brew cycle: when on,
7. Green delayed start light: when on,
a time delay has been set
14
V.1.0
description of the appliance (programmable coffee machine)
3 1
6
coffee is being brewed
3. Screen
4. Set minute key
5. Set hour key
6. Program key
before initial use
• Carefully rinse all removable parts (glass jug, permanent filter and filter holder) with hot
soapy water, following the instructions in the "Cleaning and maintenance" section. Rinse
with clean water and dry carefully.
• Fill the container with cold water up to the maximum level indicated.
• Run the coffee machine for two cycles using only water (no coffee). Pour away the hot
water collected.
2
using the device
Setting the clock (24-hour display)
(programmable coffee machines only)
1. Plug the power cord into the mains outlet. The LCD screen displays a flashing "12:00".
2. Press on "H" (Hour) to move forward by an hour. You can move the time forward faster
by keeping the button pressed down for more than 2 seconds.
3. Press on "M" (Minute) to move forward by a minute. You can change the minutes faster
by keeping the button pressed down for more than 2 seconds.
Preparing the coffee
1. Open the top lid and fill the water tank with drinking water. The water level must never
exceed the MAX mark indicated on the tank.
2. Place the filter holder into its bracket, ensuring that it is properly in place, otherwise you
will not be able to close the top lid. Place the permanent filter or paper filter inside the
filter holder.
3. Add ground coffee into the filter. Usually, a level spoon of ground coffee is used per cup,
but the quantity can be adjusted according to taste. Place the top lid firmly in place.
4. Place the glass jug with its lid closed horizontally on the hotplate.
5. Press on the "ON/OFF" button. The "ON/OFF" light turns red, and the coffee starts to
percolate.
15
V.1.0
using the device