Modes Of Operation - Salvis RH-EM Instructions D'installation Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. OPERATION

3.1 Modes of operation

- Full power left and right 4.0 kW (RH) / 4.6 kW (HL)
- Keep-warm mode with reduced heating power 1.0/1.15 kW
- Half heating power left or right 2.0/2.3 kW
3.2 Basic models: RH-EM / HL-EM
Electromechanical control
- Move reflector to top position.
- Place dish or platter on the grid or plate.
- Switch on unit, turn switch to desired heating power.
- Lower reflector to the desired position.
- When the desired browning is achieved, switch off the unit and move the reflector to the top
position.
- Either remove the plate or turn the switch to the keep-warm position.
3.3. Standard models: RH-ET / HL-ET
- MAN mode:
Turn the switch to MAN mode and then proceed as described under 3.2.
- AUTO mode: Turn the switch to AUTO mode and then proceed as described under 3.2.
- After the timer is set (0-15 minutes) the unit starts up.
- When the time has elapsed, an acoustic signal sounds and the heat is switched off.
Full power heating left & right
Full power heating right
Full power heating left
Keep warm
Timer max. 15 minutes
(only in the "AUTO" mode)
AUTO mode with timer
MAN mode without timer
8 / 9
Typ RH
Typ HL
4.0 kW
4.6 kW
2.0 kW
2.15 kW
2.0 kW
2.15 kW
1.0 kW
1.15 kW

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rh-etHl-emHl-et

Table des Matières