Publicité
Machine Operation
GB
Raising/ Lowering
the Floor Tool
After preparing the floor (see previous
section), we are now ready to set the
controls to suit the cleaning conditions.
Before any settings can be applied,
ensure the brush deck is lowered.
Move the floor tool lever to its
lower position.
Note: Do not pull the machine
backwards with the floor tool in the
lowered position, this could possibly
damage the blades.
Setting the Cleaning Controls
Insert the isolator key into the rear of the machine and turn to the
on position.
To check the battery level, pull one of the Triggers (A) or press
button (B).
Brush Pressure
1
2
50 Ah Model
+
-
Adjust water flow using the fluid control tap.
B
A
100 Ah Model
40
Your machine has been designed to work
at the optium brush pressure with a weight
set added into the 50 Ah model in place of
an additional battery 100 Ah model.
!
IMPORTANT
If the brush motor keeps
overloading consider using a
different type of brush.
Heavy brush load decreases
the available battery run time.
!
Publicité
