Publicité
Machine Set-up Guide
GB
Filling the Clean Water Tank
A
To fill the clean-water tank, use the FLEXI - FILL pipe from either a tap
or hose pipe (Fig. A & B).
The large cap can also be used for filling from a bucket or suitable container (Fig. C).
Fill the clean-water tank to MAX line indication on tank, including cleaning chemicals if
required. Follow chemical manufacturing guide lines.
The clear dump hose at the rear of the machine can be used to see the level of the
clean-water (Fig. D).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt,
etc.) are not allowed to enter the clean water tank during the filling process. If
using a bucket or similar, ensure it is always clean and free from debris.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical recommended for use in auto
scrubber dryers, dilute to the manufacturers specification. For further guidance on
hazardous substances refer to health and safety instructions online.
!
Always ensure that chemical manufacturer's safety guidelines are followed.
Handle Height Adjustment
Using the handle position lever, lower the handle to a comfortable working position.
A
!
Do not operate machine unless the Operator Manual has been read and fully understood.
The machine is now ready to be moved to the cleaning site.
Before performing the cleaning operation, place out appropriate warning signs and sweep or dust-mop the floor.
WHEN HANDLING AND MIXING CHEMICALS
Only use chemicals recommended for use in auto scrubber-dryers.
B
B
IMPORTANT
34
C
D
D
!
!
Publicité
