Ameriwood HOME 3325348COM Instructions D'assemblage page 22

STEP 14
IMPORTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVER. FOLLOW
THESE INSTRUCTIONS TO INSTALL THE ANTI-TIPPING SAFETY BRACKET PROVIDED WITH THIS
PRODUCT.
OPTION 1: Attachment into a wall
stud (preferred method)
Using a stud finder, locate a stud in
the wall. Place your unit against the
wall, with the safety bracket aligned
in this location. To make driving the
screw easier, you can drill a 1/8"
diameter pilot hole (3mm) through
the safety bracket into the stud.
Drive the screw through the safety
bracket into the wall stud. Tighten
the screw that was not fully
tightened in step 11.
OPTION 2: Attachment into drywall
Locate your unit where desired
against a wall and mark the wall
through the safety bracket, then
move your unit aside. Drill a 3/16"
diameter hole (5mm) into the
wallboard. Tap the wall anchor into
the hole until it is flush. Move your
unit into location and fasten the wall
bracket to the wall anchor with the
screw. Tighten the screw that was
not fully tightened in step 11.
12c
12d
(x1)
#A84050
12c
22
For Masonry, Concrete, or other
wall materials:
Consult your local hardware store
for appropriate anchors to securely
attach the safety bracket.
hole
12d
wallboard
stud